How to Activate OVHD Decoder in Botswana

The decoder will pick up the OVHD signal automatically. The decoder must be activated using the cellphone by entering *120*6843*1# and then following the menu. Setup guide How to connect. If you already have a satellite dish and would like to install and activate your decoder, please follow the following steps: To connect your decoder to the satellite dish, you will need to connect.

Connect the cable from the dish to the LNB-IN port and switch the OVHD decoder ON. The decoder will pick up the OVHD signal automatically. The decoder must be activated using the cellphone by entering *120*6843*1# and then following the menu. The following errors can be cleared by following the easy steps below

The decoder must be activated using the cellphone by entering *120*6843*1# and then following the menu.

You can see if the channels have been recovered by changing the program or simply pressing ok on your remote to display the list. Alternatively, please dial *120*6843*1# select Option 1, then enter your STB number to reactivate your decoder

Your decoder may reboot and update its software during the activation. Please allow a few minutes for this. If you have no channels, press the HELP button on your Openview remote to check your signal strength and quality levels. These levels can be found at the bottom of the help screen.

To connect your decoder to your dish: Connect the cable from the dish to the LNB-IN port and switch the OpenView HD decoder ON. The decoder will pick up the OpenView HD signal automatically. You will need to activate the decoder by following the instructions in the box to start receiving your free entertainment.

How do I check my Openview signal?

Have you lost your signal? Search for your channels by pressing menu>installation>channel search>pin 0000>ok, then switch to Transponder 4 (TP 4 11996H), frequency 11996 H.

How do I enable the Openview decoder in Botswana?

Dial the number on the bottom right-hand corner using a cellphone *120*6843*1# and follow the prompts. Use your STB number to complete your decoder activation.

What is the postal code when activating OVHD?

3. Under setting go to installation and press ok. A parental pin code will be required, enter 1234.

Why is my OVHD not picking up the signal?

If you are experiencing OVHD no signal message, it is probably a result of harsh weather conditions. It could also be a problem resulting from faulty accessories. Don’t worry; your DStv decoder displays an error message only because it is experiencing signal problems.

How do I check my Openview signal?

Have you lost your signal? Search for your channels by pressing menu>installation>channel search>pin 0000>ok, then switch to Transponder 4 (TP 4 11996H), frequency 11996 H.

What should I do when my TV says no signal?

Check the cable connections between the TV and your video device or receiver. Change the channel or try a different input device or movie. The received signal may be weak. If your TV uses a cable or satellite box, you may need to contact your service provider for further assistance in improving the signal strength.

Why does my TV say no channel is registered?

That’s a message from the TV, it probably means the TV input is set to ATSC over-the-air, use the TV remote to step through the inputs until you find the correct one for DirecTV.